Metal Roof Installation Thompson Field TX

How Metal Roofs are Installed in Thompson Field TX

Most metal roof installations in San Antonio come as pre-assembled panels covering the entire roof area and can be installed without cutting or shaping. However, some styles may require minor trimming to fill in around pipes and other obstacles. The panels are attached directly over your existing roof decking with screws, which allows them to expand and contract like the rest of the roofing surface with changes in temperature and weather.

Metal roofs can be installed on either standing-seam panels set in place or on nail-down panels attached over your existing shingles or sheathing. Standing seam is a shaped panel that interlocks together and does not require any nails to hold it in place, so it is a rustic look typically used with metal siding. Nail-down roofs are faster to install and easier to repair since there are no seams for water to leak through, so they are the most popular choice for putting on over an old roof that you want to preserve.

Metal Roof Installation San Antonio: Project Timeline

Prepping the Roof in Thompson Field

Contractors should also inspect your existing roof for loose shingles, cracks, and other signs of wear that may need to be repaired first. This is especially important if you plan to use a nail-down system since it won’t be as watertight if your existing roof is not in good condition.

Before you begin:

1. Ensure the surface is clean and dry since even a small amount of debris can leave marks that cause rust spots on your new panels.
2. Cover plants with tarps to keep them out of the way during installation.
3. Remove all old roofing materials and nails to make your life easier during the project.
The metal panels come with a ridge vent at the top that can be left or covered with an aluminum mesh panel for extra protection from wind and rain. The best standing seam roofs have a layer of rubber along the bottom that protects them from moisture build-up if you plan to use the panels without the mesh.

Metal Roof Installation Components

Installation Methods for Thompson Field, TX

The same metal panels are used for both nail-down systems that attach over your existing roofing shingles and standing seam roofs that utilize interlocking pieces. The only difference is how you put them in place, so if your old roof is in good shape, you can put on an entirely new metal siding exterior using the same panels you just took off.

When installing the existing shingles, start with the drip edge and corner flashings before attaching each panel for waterproofing. If water gets behind the boards, it will cause leaks, so ensure everything is sealed well before putting your new roof on top. Once the nails are hammered in place, roll out the ridge cap and attach it to hold down each end of the panels.

Standing seam roofs use an interlocking system that will need to be fastened together at each joint where they meet up for a watertight seal. You can cut panels with snips to fit around your skylights and vents, but otherwise, the same installation steps apply here as well. Depending on which style you choose, the gap between panels needs to be sealed with a cap or mesh to protect it from wind and rain.

When installing over existing shingles, make sure to remove all nails that are below the new metal panels. It’s also essential to remove any debris from your old roof before putting on the new one. Otherwise, you could end up with rust or oxidation spots where there used to be shingles left in place.

Once everything is cleaned up and fastened down, it should only be a few hours at most before you’re ready to roll your new metal roof installation.

Hire an Experienced Metal Roofing Contractor Near Thompson Field Texas

To determine which style of metal roofing is best for your home, you need to know exactly what type of construction materials are already in place. If the decking is wood, you will want a standing seam roof or nail-down panels that attach to existing shingles. However, if your current roof is steel or concrete, an entirely new fastener system will need to be installed with interlocking panels.

When putting on a metal roof, make sure you keep the gap around vents and pipes clear for proper ventilation, especially if you live in an area where it’s hot most of the year. On top of this, choose a style that won’t turn out too dark since radiant heat could cause your home to warm up more than you’d like.

You also want to make sure the material is rated for high wind areas, especially if you live in an area that experiences hurricanes or tornadoes. It’s always a good idea to check with your local building department before putting on a metal roof since not all of them will allow it, even though it’s a cost-effective material that is built to last.

Not only will this improve your home value and resale value, but you’ll also save money by not having to turn up the heat so much during the winter.

Metal roof installation is a do-it-yourself project that should only take a few hours at most before you have entirely new siding on your entire house. The panels are lightweight, durable, and require less maintenance than traditional clay or concrete tiles. Plus, they look great with any home style, including ranch, cape, colonial, or craftsman.

Once the project is complete, you’ll be ready to enjoy your updated metal roof that will stand the test of time in every weather condition imaginable. Not only will you save money on heating bills each month, but any contractor you hire for this job will have experience with all different types of panels and installation methods for each style of home.

In conclusion, metal roof installation is a great do-it-yourself project that is easy to complete with the right tools and know-how. Not only does this improve your home’s look, but it also gives you less rood maintenance than with traditional tiles and shingles.

Contact Us for Metal Roof Installation in Thompson Field

Sed risus nisi, eleifend eget elementum egestas, imperdiet sed mauris. Aenean ut tristique arcu, sit amet tempus nisl. Nullam sagittis mattis ipsum, non viverra arcu. Vivamus blandit metus eu scelerisque maximus. Aenean erat lacus, eleifend quis dignissim ut, lacinia bibendum orci. Maecenas at dolor diam. Quisque convallis magna quam, at euismod lorem placerat quis. Fusce venenatis sit amet purus eu ornare. Aliquam maximus efficitur erat, vitae tempor erat scelerisque id.

Learn more about metal roof installation and the roofing services we offer.